Oil pressure sending unit

Started by SpeedDemon, April 24, 2005, 06:19:42 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

SpeedDemon

April 24, 2005, 06:19:42 PM
Does anyone know where the oil pressure sending unit is, I can't seem to find it :oops: ? I think mine is bad and I need to replace it. :x
1990 TGP: stock minus the K&N air filter and high flow cat
1999 Oldsmobile Aurora: What a step up from my 95 Monte Carlo
1967 Plymouth Belvedere II: 318 c.i., Flowmaster Exhaust, and in deserate need of new rear tires.

Invasion1

#1
April 24, 2005, 06:53:05 PM
is it not the sensor that is beside the oil filter on the oil cooler?

R Dubya

#2
April 24, 2005, 07:53:47 PM
that's it.  screws right into the filter/oil cooler.
Ryan Warren
'89 TGP
It doesn't run anymore.

turby

#3
April 24, 2005, 08:33:11 PM
Directly between the oil filter and starter. You can't miss it. If you take your oil filter off you can loosen it with channel locks or a crescent wrench. It shouldn't be too tight.

SpeedDemon

#4
April 26, 2005, 03:51:13 PM
Ok I found it, and it was a pain to replace. It's actually under the oil filter and behind two coolant lines.  Thanks for the help guys. :D
1990 TGP: stock minus the K&N air filter and high flow cat
1999 Oldsmobile Aurora: What a step up from my 95 Monte Carlo
1967 Plymouth Belvedere II: 318 c.i., Flowmaster Exhaust, and in deserate need of new rear tires.
Print
Go Up Pages1
User actions