Brakes again!!! :evil:

[olds1992]

OK, here it goes.  I had my PM III rebuilt by Prior back in the middle of July.  I installed it in early August and have been very satisfied.  However, I noticed the other day that there was fluid dripping from the car.  I take a look, and it is brake fluid.  After further investigation the fluid appears to be coming from the lower part of the resivior and then dripping down to the sub frame where is runs alonf the frame and falls all over the place.  I know it is the resivior because that is the only place that has fluid on it and if I sit under the car and look up I can see it drip from the metal part that the resivior is attached too.  

So I was wondering if there is a bolt of some sort that holds the resivior to the shaft underneath it that may need tightening?  Or should I take the unit out and send it back to Prior?  

If I can't get these breaks straightened out, I may just sell the car.