Crossover?

Started by MechTGP, October 19, 2008, 10:08:43 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

MechTGP

Hey guys i was reading up on corssover leaks and stalling was mentiond. mine stalls but only when i quickly pop the gas at idle(so far) and while in park it surges between 900 and 1100 rpm.. maby alittle steeper than that but it surges for sure. i replaced the O2, fixed a vaccume leak and the borke intake hose(inbetween the turbo and throttle body). also every once in a while it will dorp idle quite a bit and at the same time it sounds like the ABS? is doing something. or atleast it might sound a little like an electric motor. any ideas?

TGed

Hows your voltage readings?  Flaky volts can cause annoying driveability concerns.
http://www.tgpforums.com/index.php/topic,5214.msg38936.html#new

-Don't go around saying the world owes you a living; the world owes you nothing; it was here first.-

-Assume nothing, question everything.-

MechTGP

I will check that out tomorrow at school.

bake82

If the voltages are fluctuating check the AUX battery post. They come loose and can cause some issues.  Also check all your grounds, make sure all are good and clean.

Kyle


1988 Cutlass Supreme, White/Black Leather, 3.1 Turbo 5 spd, coming soon  95k miles

cobracmdr

could be a vac leak or other other sensor issues as well.  Really in a these old vehicles you have to validate you sensors and vac lines are not bad before jumping to other more far fetched problems.

Ken

1989 Turbo Grand Prix - missed very much!!!!
2010 Camaro 2SS/RS LS3 M6 12.01 @117 mph - Inferno Orange Metallic, long tubes, x pipe, Cat back, all 3" pipe 321 SS, vararam intake, LC-1, diy tune
01 Grand Prix GTP - 3.4 pulley, plog, k&n drop in, u-bend & resonator delete, tuned
03 Suzuki SV650N - zx10 shock, racetech springs/emulators, streetfighter