Found cruise control problem when replacing master cylinder

[blackbeauty90]

I took the cruise unit out to get my master cylinder out, and found a rubber hose by the turbo comepletly charred up and craked open.  Where does this hose go to so I can replace it?  Is it a very hard job (don't forget I will have the master cylinder out so maybe it will be easier?)

[Chris A]

If you are talking about the larger rubber hose that goes to the large port on the cruise servo, it goes inside the car to a switch above the brake pedal. Its a vacuum switch that will bleed off the pressure if the eletronics fail so it doesn' t get stuck at open throttle. I would get a connector and a new section of hose and splice it in. Replacing the hose completely probably isn't easy.

Chris

[eclipse5302]

Replacing the hose completely probably isn't easy.

It's not seeing as how the hose is glued /sealed to the firewall connector as it passes through the firewall.

Jason