Did you get the Taylor wires? What is your impression of them? What was the Taylor / summit number you ended up using? Did you need to make them yourself?
Thanks
Hi, Yes I did get my Summit shipment and the parts are installed. I went with TAY-74230 (Red color), they worked good and the color really accents the engine bay. They cost $39.69 and it's a custom fit 8mm spiral-core set for the LH0/LG5 (VIN T and VIN V [turbo]). The only drawbacks is there are a few wire looms that wouldn't close cause the wires are too fat and the wires were a few inches longer than the old ones I pulled off. I was planning on posting a little write-up complete with digital photos and wire length measurements along with the other parts I installed. If you dont mind, can you send me a reminder email or Private Message and I'll post back on Saturday with the whole shebang?
Thanks, Have been waiting a month to see how your worked otu before I got mine.
E-mail enroute.
Whoops!!!! I posted the wrong part number above. I posted the P/N for a spark plug boot puller tool (TAY-43392). The correct P/N is TAY-74230. Sorry for any confusion. I'm writing the real article right now.
Quote from: TookyCatWhoops!!!! I posted the wrong part number above. I posted the P/N for a spark plug boot puller tool (TAY-43392). The correct P/N is TAY-74230. Sorry for any confusion. I'm writing the real article right now.
So your saying 74230 is the correct # and the one you gave in your first post is wrong? The number you gave first is 74230. So which is the correct number?
I apologize, you'll have to excuse me; I'm a goofball :) I edited my original post so it no longer shows the incorrect part number. Here is a photo of the box, to clear any confusion:
(http://www.nconnect.net/~tookycat/tgp/plug_wire_box.jpg)
OK,thanks for clearing that up. I thought I was going nuts for a minute there.
Actually it was my fault, sorry for that. It's all good now 8)