Well i finally got my gauges for the Turbo CS
www.dakotadigital.com
and my gauges have a solid black bezel not the blue in the pics
Boost/Vac
(http://www.dakotadigital.com/cartimages/prd_sm_337.jpg)
EGT
(http://www.dakotadigital.com/cartimages/prd_sm_346.jpg)
Air/Fuel
(http://www.dakotadigital.com/cartimages/prd_sm_307.jpg)
I have them going in today very custom so stay tuned for some pics later today or tomorow. :wink:
Ok for the Boost/Vac Gauge Vaccume line...
I have my BOV line hooked to the old location on the upper intake where the trans modulator line used to be....by the TB.
it should be fine if i install a "T" and run the Gauge feed line off that correct?
thats the most accurate place i figure but if anyone can back me up here i would appreciate it :D
The Air/Fuel is pretty easy its just wiring :wink:
As for the EGT Gauge.....mounting the Bung and sender in the Downpipe......yikes!!!!!! :shock:
anyone have any thoughts on that??
thanks
Dave