I am having problems with the fan on/off set points in Tuner Pro RT. It is not taking the values I am putting in. Now if I use an older .bin that was not edited by TP RT then they work fine. With the settings I have now they do not turn on till real late/hot.
I sent Mark an email and his response was this...
QuoteSounds like either the conversion equation in the XDF is incorrect, or the address of the data is incorrect. You can verify using the hack file here: (link to Moates site with Hack wording)
Well when I look at the hack layout wording it is like I am trying to read Hebrew. Anyone else having this issue or did I screw up the definitions somehow?
Let me know all!
-Kenny :icon_cool:
Hmm, mine was 85*C on and 89*C off, and it's still correct in Tunerpro. Works perfect. No issues here.
Dave and Adam are saying the same that they are not having problems either. I guess I did something somewhere to hose things up. Doesn't surprise me witht he luck I have been having lately! :icon_rolleyes:
Well I think I am going to reload TunerPro and start over. I have three .bins that are the original works plus what Adam and I worked on. No biggy.
Thanks guys for the replies! :icon_cool:
Ok goin by my disassembly,Fan 1 on with ac off is at addressee 3F6.Fan 1 off with ac off is 3F7.Fan 1 on with ac on is 3F8.Fan 1 off with ac on is 3F9.Next,Fan 2 on with ac off is 3FC,Fan 2 off with ac off is 3FD,Fan 2 on with ac on is 3FE,Fan 2 off with ac on is 3FF.In tuner pro Fan 1 enable is 3F8 and fan 1 disable is 3F9.Fan 2 enable is 3FE and fan 2 disable is 3FF.In English the xdf is wrong.If you wont your changes to the fans to work either cut the ac on OR change the addresses in tunerpro to to use the ac off settings.I have never messed with the fan stuff,I run my pusher on a toggle switch and the puller settings are fine for me.Hope this helps,later...Adam