my idle has been kinda surgy for awhile
I noticed in my last datalog, after I installed a heated o2, that the INT was going down a little to like 120-124.
which is the correct table to adjust the idle? "FUEL VE % vs RPM" ?
the BLM stays at 128, just the INT is going down a little
edit: heres the datalog
http://www.rogepost.com/dn/4scu
everythings ok now. it was a bad heated o2 sensor.
I noticed when i first installed it that the o2 cross counts werent going up very fast at all, no matter how long I waited.
I put the 1wire back in and the BLM&INT both stay at 128 during open&closed loop, and o2 cross counts going up quick like normal