Just curious if anyone may have a walk through for this. I have a rebuilt turbo that I got from another member that has almost no run time on it but the seals went bad. Should I just rebuild it again or could I just replace the seals?
Not a good walk-through- no torque specs ...but similar to what I did. Not sure if my turbo was balanced as a whole where both turbine and compressor were balanced together or turbine by itself and then the compressor but didn't give me any trouble. I did brake clean the compressor wheel and mating surfaces and nut as not to have any lube on them when torquing down the nut on the compressor wheel-lube= compressor slip.
http://www.driftworks.com/forum/technical/60665-how-rebuild-your-t28-turbo.html
also good read
http://www.gnttype.org/techarea/turbo/turborebuild.html
Forgot about this one TGP specific.
http://www.tgpforums.com/index.php?topic=4580.0