Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - NastyTGP

#1
Hi,

I need the part # for the o-ring that goes in the oil cooler?  Does anyone have a diagram or part #?

Thanx
#2
For Sale / Want to Buy / WTB: EGR Tube
November 23, 2004, 10:04:26 PM
I am looking for a EGR tube for an 89 TGP......let me know what you have!

E-mail at rage956@yahoo.com

TIA  :D
#3
Problems & Solutions / Heater core leaking.........
September 23, 2004, 09:21:34 AM
Thank you for replying,  thanx for the offer but I just bought one.  I apprecate the help.

Brian :D
#4
Problems & Solutions / Heater core leaking.........
September 22, 2004, 04:50:22 PM
I traced a coolant leak that is comming through the wires near the fan, the lines go throu the passenger side firewall!?  How hard is it to replace a heater core? any tips someone could give me?!  How many hrs am I looking at?

TIA
#5
probably 1/2 an hr - 45 mins...........I'll be replacing the motor, you live & learn!
#6
Problems & Solutions / thanx for replying
July 31, 2004, 09:14:41 AM
I will do that but I'm worried that all the shavings went into the cylinder walls, & will scrape up the sides & will Eventually kill the motor due to loss of oil pressure, I think I can get a motor for $500.  what to do??? I'll try that & hopefully everything will turn out good

Thanx again
#7
I blew the turbo pretty bad, the whole turbine was chewed up:evil:......I took the intercooler off & metal filings/shavings were in there with alot of oil......should I be looking for a new motor soon because of all that crap is in the pistons, cylinder walls, can I some how flush it out? What my best option?

TIA
#8
I am looking for a stock T-25 Turbo, must be in good condition, no shaft play, no oil leaks.....email me @ rage956@yahoo.com

Thanx 8)
#9
Hi,

I just replaced the radiator in my 89 TGP, but I must have blown a head gasket while I overheated it, antifreeze keeps getting low & bubbles/foam were in the overflow, what are the GM part # for head gaskets, ARP head bolt part #'s, I probably warped the heads, anything else I should know/do?!  How much should I be looking at for this job?!

Thanx
#10
I don't have the budget to spend almost $230 on fuel injectors...so I found these http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&category=33554&item=2460483517 do you think this would work just fine or should I just get 29'ers??

TIA
#11
nevermind, I didn't realize one of my parking lights were out, put a new bulb in & everthing works fine! :roll:  :roll:
#12
Hi,

I've noticed that when I take a right turn, my right blinker stays lit up, but does not blink.  I checked my hazards & they blinked, do you think it could be a bad fuse? anyone else have this problem?

Thanx :)
#13
General / Tune up - Part #s needed.......GM/Ac delco
December 23, 2003, 11:57:24 PM
I need to do a tune up on my car.  I need some part #s, i looked every where, search, & nothing came up. I need original GM/ AC Delco, no aftermarket (Fram,wix,etc.)


Ignition Coil
Fuel filter
Tranny filter
spark plugs
radiator cap

I want to order from gmpartsdirect

Thanx :D
Brian