Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - kuntzie

#1
For Sale / Want to Buy / Re: GB: 3" downpipes
November 08, 2010, 10:01:18 PM
im not in, and matt is the protype car, so really not included in this deal as hes got a differnt swal for using his car
#2
For Sale / Want to Buy / Re: GB: 3" downpipes
November 06, 2010, 02:09:30 PM
if i cant get more then 4 then the price is 400,

i can possibily get it down to 300 shipped if we get 10 orders
#3
it will clear.
#4
For Sale / Want to Buy / Re: GB: 3" downpipes
November 04, 2010, 04:19:45 PM
ok we are over 1/2 way there, they can be done by the 15th forsure if we get enough people together
#5
For Sale / Want to Buy / Re: GB: 3" downpipes
November 02, 2010, 08:39:10 PM
ya we can do 2 of them
#6
For Sale / Want to Buy / GB: 3" downpipes
November 02, 2010, 07:29:35 PM
direct bolt in 3" downpipes, will bolt up to your 5 bolt flange and end around the cat, you will have to adapt to your system at that point.

these will be made by cartuning performance and of 304 stainless steel, o2 sensor bungs will be also added

$350 shipped to your door,

matt has agreed to be the test fitter/ prototype and as long as its ok with him i would get his paypal to hold deposits

any intrest? would need minimal 7 people
#7
all sold
#8
Performance / Re: Spec Clutch Stage 3
May 27, 2010, 11:36:25 PM
im runnign a stage 5 in my 2001, DD, its nuts, a regualr stage 3 is fine for the streets after a day or so of learning
#9
Performance / Re: Spec Clutch Stage 3
May 24, 2010, 06:28:53 PM
just dont buy a stage 3+ they are junk
#10
heads and up sold and all exhaust parts are sold. i have a cammed block and the intercooler setup still
#11
getting a new cabel for the moates emulator and then it wil be up


piping is 2.5" powdercoated gold, flange for a BOV and the intercooler is about 27x12x3 IIRC
#12
heads and up sold
#13
For Sale / Want to Buy / Re: FS FMIC setup
March 11, 2010, 01:34:59 PM
all of my tunes are for 5-speed and none use stock injectors, so no
#14
bump- im willing to part out the top end of the engine, extenive port and polish work to heads and intakes
#15
For Sale / Want to Buy / FS FMIC setup
March 09, 2010, 09:35:08 PM
will need slight modifactions to work in a stock tgp, but not insaine.

battery would have to be reloacted to the back or mount where the stock intercooler was,

i think you will need a 45" silicone coupler to mount to the stock turbo, but im unsure you may need a litlle more work, like i said unsure.

the tow hook on the one side has to be shaved down on the subframe.


piping is gold powdercoat, intercooler is about 27x10x3 but ill have to measure tomorrow.

has a turbosmart blow off flange installed


$500- intercooler and t-bolts were more then that on their own