thats a 3" drop spring, birchmount make 2" or 2.5" drop springs aswell i dont remember if its 2 or 2.5)

I shaved my blocks down to a third of their original thickness.

And, what Jeff said above.

LOL @ stacking the blocks

if one block stock is ONE INCH! then 2 blocks stacked (if possable) like you said would be????

Simple math here...

Quote from: Invasion1 on February 02, 2007, 07:06:09 PM
LOL @ stacking the blocks
if one block stock is ONE INCH! then 2 blocks stacked (if possable) like you said would be????
Simple math here...

Dude... I wasn't asking how thick the blocks were, I was just asking how much each block RAISES the rear end.  Thats all.  :icon_neutral:

the thickness of the blocks IS the amount the rear will be raised......

this is not hard "dude"

one block = one inch
shave 1/2 off that block = lower 1/2 inch from what it was
Add 2 blocks (if possable) = raise 2 inches

I didn't know- that is why I asked.  Plain and simple.

Also Nick if you don't like how low Matt's TGP is...then if you get one...make sure it's not as low.....as the guy can make them to lower any amount....

Quote from: Invasion1 on February 02, 2007, 08:51:53 PM
the thickness of the blocks IS the amount the rear will be raised......
one block = one inch
shave 1/2 off that block = lower 1/2 inch from what it was
Add 2 blocks (if possable) = raise 2 inches

You should have said that in the first place- this is exactly what I was asking for, not the harassment over the simple questions I asked.  Done

Its not really THAT low.......

heres the rear leaf in my car with the loewer front aswell.. as matt said it isnt bad