If anyone has any stock GM MEMCals laying around that they want to make a few bucks off of give me a shout. This of course is the piece (normally blue) inside of the ECM that holds the programmable chip and knock sense circuitry.

-Kenny

PM Sent

i literally have like 100-150 of these

What you willing to pay

I'll pay $5 a piece for them. I would like to have 10 on hand if possible.

IIRC the engine you run the MemCal off of needs to be from a vehicle with the same amount of cylinders.  so if Kenny wants TGP chips to burn they'll need to be from a V6 car.

all mine are from v6's... kenny ill give you 50 of them for $100, shipped if you want ( i know you only want 10 but still 10 x $5= 50... so making you a deal if your intresed

Sounds good.

As soon as I return from my working vacation I will get with you and buy them. I will be returning on the 19th.

-Kenny

Kuntzie,

PM me your paypal or let me know how you want me to pay for them and I will get you the money right away.

-Kenny

pm sent

Money sent via PayPal.

Thread locked.

Thanks for the deal man!
-Kenny

This ended up not happening. I NEED stock MEMCals!

Let me know what you guys have!

-Kenny

I might have a couple of these laying around, I can check and get back to you.

Quote from: TGPilot on February 26, 2007, 11:29:38 AM
This ended up not happening. I NEED stock MEMCals!

Let me know what you guys have!

-Kenny

Are you looking for TGP memcals or just plain v6 memcals.I have LOTS of f-body stuff.Mostly 85-89 MAF memcals.I've repined lots of MAF f-bodys to SD.I also have quite a few of v6 memcals that I've collected over the years that came out of 2.8-3.1 cars(olds,chevy,pontiac,etc...)lemme know...Adam

Adam,

I need MEMCals out of V6 GM cars so I can drop in a EEPROM, burn my program for the LG5 that's using a 7730 ECM, and get them to customers.

Are you saying there is a difference between the chip pin location on a MAF as compared to a SD car?

Let me know...Kenny

Quote from: TGPilot on February 27, 2007, 09:08:23 AM


Are you saying there is a difference between the chip pin location on a MAF as compared to a SD car?

Let me know...Kenny

ALL memcals have a limp home mode program inside the memcal,totally independent from the eprom.So you could use any memcal as long as you never need limp home mode.Limp home mode is for when 1 or more sensors fail.When I burn chips for customers I ALWAYS use one for the application I am working with.Some memcals have the knock circuitry in them and some use an EST module mounted in the engine compartment.MAF cars use an EST module and SD cars have the stuff in the memcal(about 80%)l.As far as you question all the chip pins are the same,I was just referring to repining the 165(MAF)ecm to the 730(SD)ecm for F-BODYS.Done lots of that stuff  ;) later..Adam