hood release lever

Started by tyroelite, August 31, 2003, 01:05:49 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

tyroelite

August 31, 2003, 01:05:49 PM
How do I remove/replace the hood release lever? The one on my tgp is broken and I would like to move the one from my old grand prix into the broken release's place. I see how to release the cable but i can't tell how to remove the pin that the lever rotates around... anybody have any ideas?

god910

#1
August 31, 2003, 06:44:29 PM
You should be able to remove the whole thing.  I can't remember off hand, but I think after you remove the cover it is like two screws.  Have been wrong once before though.
1990 Turbo Grand Prix Black Sunshine
282 5 speed, Custom Chip, 1G DSM BOV, K&N on turbo, Centerforce Clutch, Accel 8.8 Wires, no kat, straight exhaust, TB bypass (200HP), Jeff-M cro$$over ;)
Jay Warfel
Muncie, IN
2nd TGP "TestBed" 90, Black JeffM TG160 & X-over, ractive filter, 15.21 @ 90 mph
2003 Sonic Yellow Subaru Impreza WRX  Turbo XS Stage 3
Perrin GT35R, 2.5 STi Block, JDM 6 speed swap underway.
Goal: 450 AWHP, mid 11's.

tyroelite

#2
August 31, 2003, 07:10:04 PM
I was thinking I should be able to also but the carpeting won't pull back far enough to find any screws.

GPChief

#3
August 31, 2003, 08:46:23 PM
move the seat back all the way then tke a "stubby" crosstip / phillips and undue the two screws.  The plastic cover will come off.  If y9ou want to change the actual lever, then you must remove the cable end.
2004 GTP -  3.8 Blown - Only modding for MPG.
1997 GTP  - 3.8 Blown - Too many mods to list.
1996 GTP - 3.4 DOHC - Twin to my 1997.
1995 SE - soon to be a 3.8 turbo car.
1990 TSTE x 2 white cloth
1990 TSTE x 1 maroon leather
1990 TGP - 5 speed.
Print
Go Up Pages1
User actions