Socket size...

Started by TGPrix., January 12, 2004, 04:06:50 PM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Print
Go Down Pages1
User actions

TGPrix.

January 12, 2004, 04:06:50 PM
Does anyone know tha socket size for that big ass bolt on tha HUB and Bearing assembly on tha front left tire...

R Dubya

#1
January 12, 2004, 04:24:15 PM
I think it was 2" maybe 2 1/4" I'm not sure though.
Ryan Warren
'89 TGP
It doesn't run anymore.

god910

#2
January 12, 2004, 06:08:26 PM
Well, it's metric, and I think 32mm.  If you goto buy one, there is a special tool called a GM axle nut socket.  Just match it up w/ which one you need.  (There should be some kind of chart or something)
1990 Turbo Grand Prix Black Sunshine
282 5 speed, Custom Chip, 1G DSM BOV, K&N on turbo, Centerforce Clutch, Accel 8.8 Wires, no kat, straight exhaust, TB bypass (200HP), Jeff-M cro$$over ;)
Jay Warfel
Muncie, IN
2nd TGP "TestBed" 90, Black JeffM TG160 & X-over, ractive filter, 15.21 @ 90 mph
2003 Sonic Yellow Subaru Impreza WRX  Turbo XS Stage 3
Perrin GT35R, 2.5 STi Block, JDM 6 speed swap underway.
Goal: 450 AWHP, mid 11's.

gp90se

#3
January 13, 2004, 01:21:45 AM
36mm socket, its a little loose but always worked for me.

-Jeff
1990 grand prix
Current Status: up on bricks w/o motor

1990 TURBO grand prix
Current Status: sold to GutlassSupreme

1990 Chevrolet Blazer
Current Status: Daily Beater

sleeperred90tgp

#4
February 06, 2004, 09:30:11 AM
I just borrowed one from autozone. They have them all. :)
Quickest TGP on this planet.

:cheers:FASTEST TGP AWARD given By TGPforums!:cheers:

            Congratulations JUD! Keep an eye on your rear-view mirror for TGPilot
Print
Go Up Pages1
User actions